Please use this identifier to cite or link to this item:
Title: Electrosynthesis of molecularly imprinted polymer films on quartz crystal microbalances for the detection of some biomolecules
Authors: Hong, Shuangjin
Keywords: Hong Kong Polytechnic University -- Dissertations
Electrochemical sensors
Issue Date: 2005
Publisher: The Hong Kong Polytechnic University
Abstract: Molecular imprinting, in which specific binding sites are created by polymerization of functional monomers in the presence of template molecules followed by their subsequent removal, has been recognized as a powerful tool for the preparation of artificial receptors for specific binding with target molecules. Though molecular imprinting can be employed for the preparation of the recognition sites in chemical sensors, the development of sensors based on molecularly imprinted polymer (MIPs) is relatively slow mainly due to the difficulties in integrating the imprinted polymers to the sensor transducer. The objective of this thesis is to develop sensors for biomolecules based on electrosynthesized imprinted polymer films. In the first part of this study, molecularly imprinted polymer films of polypyrrole and poly(o-phenylenedamine) have been prepared by electropolymerization on EQCM electrodes in the presence of adenosine-5'-triphoshate disodium salt (ATP). These ATP sensors exhibit high selectivity against ADP and AMP. A pyrrole:ATP mole ratio of 2:1 was found to be the best for the preparation of the MIP polypyrrole films by electropolymerization. On the other hand, the poly(o-phenylenediamine) film has low conductivity and therefore only very thin polymer film could be obtained. Nevertheless, this allows the poly(o-phenylenediamine) MIP films to have short response time towards the analytes. The poly(o-phenylenediamine) MIP film was found to exhibit better selectivity but lower sensitivity towards ATP.
In the second part of this project, a functionalized monomer, glucose-boronate-substituted aniline, was synthesized by cyclic esterification of glucose with aminophenylboronic acid. Glucose imprinted co-polymer films of boronate-substituted monomer and aniline were prepared by electropolymerization in nonaqueous media and gradually transferred into aqueous media. At physiological pH, the EQCM sensor based on this glucose imprinted polymer film showed linear frequency response toward glucose solution in the concentration range of 2.0 x 10⁻⁵ to 7.5 x 10⁻⁴ mol dm⁻³. Substantial uptake of fructose by the glucose imprinted polymer film was also observed. This was due to the high association constant (Ka) between fructose and bronic acid. The effect of various parameters such as electrode potential, solution pH and functionalized monomer to aniline ratio on the analytical performance of glucose imprinted polymer film were examined. In the third part of this study, molecularly imprinted polymer films of acrylamidophenylboronic acid were prepared by electropolymerization on EQCM Au electrodes and Au wire electrodes in the presence of dopamine. After removal of the template molecules, a MIP film with both high affinity towards dopamine and permselectivity against ascorbic acid (AA) was prepared. The electrochemical sensor based on the MIP film was used to detect dopamine at different concentrations at physiological pH by means of preconcentration-stripping. Using this dopamine sensor, a linear relationship was observed between the electrochemical redox peak current intensity and dopamine concentration from 5 x 10⁻⁶ to 1 x 10⁻⁴ mol dm⁻³. This sensor shows negligible interference from ascorbic acid, even when ascorbic acid's concentration is as high as 1 x 10³ mol dm⁻³. The mechanism of the sensor's selectivity was discussed. The effect of various parameters such as electrode potential and solution pH on the performance of the sensor were also investigated.
Description: x, 180 leaves : ill. ; 30 cm.
PolyU Library Call No.: [THS] LG51 .H577P ABCT 2005 Hong
Rights: All rights reserved.
Appears in Collections:Thesis

Files in This Item:
File Description SizeFormat 
b18099178_link.htmFor PolyU Users 162 BHTMLView/Open
b18099178_ir.pdfFor All Users (Non-printable)4.44 MBAdobe PDFView/Open
Show full item record
PIRA download icon_1.1View/Download Contents

Page view(s)

Last Week
Last month
Citations as of Nov 11, 2018


Citations as of Nov 11, 2018

Google ScholarTM


Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.